Debug Ip Pim-Sparse Register Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
debug ip pim-sparse register [event | state] <address>
Use the debug ip pim-sparse register command to display protocol-independent multicast (PIM) sparse
source registration messages. Debug messages are displayed (real time) to the terminal (or Telnet) screen.
Use the no form of this command to disable debug messages.
Syntax Description
event
state
<address>
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 2000, 5000, and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example activates all PIM sparse registeration state changes:
>enable
#debug ip pim-sparse register state
61200990L1-35E
Displays PIM sparse register events.
Displays PIM sparse register state changes.
Specifies group address to filter.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
121