Debug Port-Auth Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
debug port-auth [general | packet [both | rx | tx] | auth-sm | bkend-sm |
reauth-sm | supp-sm]
Use the debug port-auth command to generate debug messages used to aid in troubleshooting problems
during the port authentication process. Debug messages are displayed (real time) on the terminal (or
Telnet) screen. Use the no form of this command to disable the debug messages.
Syntax Description
general
packet both
packet rx
packet tx
auth-sm
bkend
reauth-sm
supp-sm
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 1000, 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 9.1
Release 10.1
Usage Examples
The following example activates port authentication debug information on received packets:
>enable
#debug port-auth packet rx
Rcvd EAPOL Start for sess 1 on int eth 0/2
61200990L1-35E
Optional. Displays configuration changes to the port authentication system.
Optional. Displays packet exchange information in both receive and transmit
directions.
Optional. Displays packet exchange information in the receive-only direction.
Optional. Displays packet exchange information in the transmit-only direction.
Optional. Displays AuthPAE-state machine information.
Optional. Displays backend-state machine information.
Optional. Displays reauthentication-state machine information.
Optional. Displays supplicant-state machine information.
Command was introduced.
New options were introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
130