Debug Frame-Relay Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
debug frame-relay [events | llc2 | lmi]
Use the debug frame-relay command to activate debug messages associated with the Frame Relay
operation. Debug messages are displayed (real time) to the terminal (or Telnet) screen. Use the no form of
this command to disable the debug messages.
Syntax Description
events
llc2
lmi
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1
Functional Notes
The debug frame-relay command activates debug messages to aid in the troubleshooting of Frame Relay
links.
Usage Examples
The following example activates all possible debug messages associated with Frame Relay operation:
>enable
#debug frame-relay events
#debug frame-relay llc2
#debug frame-relay lmi
61200990L1-35E
Activates debug messages for generic Frame Relay events (such as Frame Relay
interface state).
Activates debug messages for the logical link control layer.
Activates debug messages for the local management interface (such as DLCI
status signaling state, etc.).
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
101