Debug Frame-Relay Multilink Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
debug frame-relay multilink <interface>
Use the debug frame-relay multilink command to activate debug messages associated with Frame Relay
multilink operation. Debug messages are displayed (real time) to the terminal (or Telnet) screen. Use the
no form of this command to disable the debug messages.
Syntax Description
<interface>
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 9.1
Usage Examples
The following example activates debug messages associated with multilink operation for all Frame Relay
interfaces:
>enable
#debug frame-relay multilink
61200990L1-35E
Optional. Activates debug messages for the specified interface. Type debug
frame-relay multilink ? for a complete list of applicable interfaces.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
102