Debug Ip Dhcp-Client Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Enable Mode Command Set
debug ip dhcp-client
Use the debug ip dhcp-client command to activate debug messages associated with Dynamic Host
Configuration Protocol (DHCP) client operation in the AOS. Debug messages are displayed (real time) to
the terminal (or Telnet) screen. Use the no form of this command to disable the debug messages.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 2.1 Command was introduced.
Functional Notes
The debug ip dhcp-client command activates debug messages to provide information on DHCP client
activity in the AOS. The AOS DHCP client capability allows interfaces to dynamically obtain an IP address
from a network DHCP server.
Usage Examples
The following example activates debug messages associated with DHCP client activity:
>enable
#debug ip dhcp-client
61200990L1-35E Copyright © 2005 ADTRAN 107