Debug Ip Pim-Sparse Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Enable Mode Command Set
debug ip pim-sparse
Use the debug ip pim-sparse command to display all protocol-independent multicast (PIM) sparse mode
information. Debug messages are displayed (real time) to the terminal (or Telnet) screen. Use the no form
of this command to disable debug messages.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 2000, 5000, and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example activates all PIM sparse mode messages:
>enable
#debug ip pim-sparse
61200990L1-35E Copyright © 2005 ADTRAN 116