Debug Lldp Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
debug lldp [rx | tx] verbose
Use the debug lldp command to display debug output for all local loop demarkation point (LLDP) receive
and transmit packets. Use the no version of this command to disable it. Debug messages are displayed (real
time) on the terminal (or Telnet) screen. Use the no form of this command to disable the debug messages.
Syntax Description
rx
tx
verbose
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 8.1
Usage Examples
The following example activates all possible debug messages associated with LLDP operation:
>enable
#debug lldp rx
#debug lldp tx
#debug lldp verbose
61200990L1-35E
Shows information about received packets.
Shows information about transmitted packets.
Shows detailed debugging information.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
129