Enable - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Enable Mode Command Set

enable

Use the enable command to enter a password for the Enable mode.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and Total Access
900 Series units.
Command History
Release 10.1 Command was introduced.
Functional Notes
The Enable Command mode provides access to operating and configuration parameters and should be
password protected to prevent unauthorized use. Use the enable password command (found in the
Global Configuration mode) to specify an Enable Command mode password. If the password is set,
access to the Enable Commands (and all other "privileged" commands) is only granted when the correct
enable password [md5] <password> on page 335
password is entered. Refer to for more information.
Usage Examples
The following example enters the Enable Command mode and defines an Enable Command mode
password:
>enable
Password: *****
#
61200990L1-35E Copyright © 2005 ADTRAN 144