Erase Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
erase [<filename> | startup-config]
Use the erase command to erase the specified file.
Syntax Description
<filename>
startup-config
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example erases the startup configuration file stored in NVRAM:
>enable
#erase startup-config
If a new startup-configuration file is not specified before power-cycling the unit, the AOS will initialize using
a default configuration.
61200990L1-35E
Specifies the name of the file (located in FLASH memory) to erase.
Erases the startup configuration file stored in NVRAM.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
145