Debug Ip Pim-Sparse Packets Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
debug ip pim-sparse packets [in | out] <interface> <interface id>
Use the debug ip pim-sparse packets command to display protocol-independent multicast (PIM) sparse
mode packet information. Debug messages are displayed (real time) to the terminal (or Telnet) screen. Use
the no form of this command to disable debug messages.
Syntax Description
in
out
<interface>
<interface id>
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 2000, 5000, and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example activates all PIM sparse packet messages (both inbound and outbound):
>enable
#debug ip pim-sparse packets
61200990L1-35E
Displays messages for inbound PIM sparse packets
Displays messages for outbound PIM sparse packets.
Specifies specific interface. Type debug ip pim-sparse packets [in | out]
interface ? for a list of valid interfaces.
Specifies a valid interface ID.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
120