Debug Ip Bgp Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
debug ip bgp [events | in | out | keepalives | updates | updates quiet]
Use the debug ip bgp command to activate debug messages associated with IP Border Gateway Protocol
(BGP). Debug messages are displayed (real time) on the terminal (or Telnet) screen. Use the no form of
this command to disable the debug messages.
Syntax Description
events
in/out
keepalives
updates
updates quiet
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 8.1
Functional Notes
If no arguments are given, the debug ip bgp command displays general BGP events such as
sent/received message summaries, route processing actions, and results. Keepalive packets are not
debugged with this command.
Usage Examples
The following example enables debug messages on general outbound BGP messages and events:
>enable
#debug ip bgp out
#07:42:39: BGP OUT 10.15.240.1[2]: Transmitting msg, type=UPDATE (2), len=142
61200990L1-35E
Displays significant BGP events such as a neighbor state change.
Displays the same information as debug ip bgp, but limits messages to the
specified direction (in or out).
Displays BGP keepalive packets.
Displays detailed information on BGP updates for all neighbors.
Displays summary information about BGP neighbor updates. (Note: updates
quiet displays a one-line summary of what update displays in 104 lines.)
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
106