Debug Crypto Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
debug crypto [ike | ike negotiation | ike client authentication |
ike client configuration | ipsec | pki]
Use the debug crypto command to activate debug messages associated with IKE and IPSec functions.
Debug messages are displayed (real time) to the terminal (or Telnet) screen. Use the no form of this
command to disable the debug messages.
Syntax Description
ike
ike negotiation
ike client authentication
ike client configuration
ipsec
pki
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Release 6.1
Usage Examples
The following example activates the IPSec debug messages:
>enable
#debug crypto ipsec
61200990L1-35E
Displays all IKE debug messages.
Displays only IKE key management debug messages (e.g., handshaking).
Displays IKE client authentication messages as they occur.
Displays mode-config exchanges as they take place over the IKE SA. It is
enabled independently from the ike negotiation debug described
previously.
Displays all IPSec debug messages.
Displays all public key infrastructure (PKI) debug messages.
Command was introduced.
Debug pki command introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
94