Avaya S8700 Maintenance Manual page 496

Maintenance Commands
If the packet length is not specified, the default is 64 bytes. You can add the
packet-length qualifier and the packet size (64-1500 bytes) to the other ping
commands. Some examples include:
ping node-name packet-length 800
ping ip-address 24.103.5.7 packet-length 100
ping board UUCSS packet-length 1000
NOTE:
The default DiffServ and 802.1p/Q parameters downloaded to a IP Media
Processor board will be used in the execution of ping and traceroute
commands which are sourced from that IP Media Processor. By
convention, the recipient of a ping will reply with the same Quality of Service
(QoS) value found in the received packet, hence the measurements
reported should reflect the behavior of the type of packets sent. IP Media
Processor-sourced pings should reflect audio transport performance and
C-LAN-sourced pings should reflect control information transport
performance.
Output
The following example shows the output from the ping ip-address packet-length
command.
ping ip-address 192.68.3.26 packet-length 1500
TEST RESULTS
End-pt IP
192.68.3.26
Screen 7-17. ping ip-address report
Field Descriptions
The TCP/IP destination address of the ping command.
End-pt IP
Location of the C-LAN circuit pack (UUCSS).
Port
Can be either
Port Type
Ethernet port (port 17).
PASS or FAIL
Result
The round-trip time (in milliseconds) of the ping.
Time (ms)
Identifies problems associated with the circuitry in the data path for a
Error Code
peer-to-peer IP layer connection
7-240 Issue 1 May 2002
Port Port Type
01C0202 PPP-PT
for PPP ports (ports 1-16) or
PPP-PT
Result Time(ms) Error Code
PASS 221 XXXX
ETH-PT
for the
555-233-143