Trusted Precedence Type Configuration Commands; Display Qos Trust Interface - H3C S5120-SI Series Command Reference Manual

The default port priority is 0.
Examples
# Set the priority of GigabitEthernet 1/0/1 to 2
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos priority 2

Trusted Precedence Type Configuration Commands

display qos trust interface

Syntax
display qos trust interface [ interface-type interface-number ]
View
Any view
Default Level
1: Monitor level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display qos trust interface command to display the trusted precedence type and priority of an
interface.
If no interface is specified, the trusted precedence types on all interfaces are displayed.
Examples
# Display the trusted precedence type and priority of GigabitEthernet 1/0/1.
<Sysname> display qos trust interface gigabitethernet 1/0/1
Interface: GigabitEthernet1/0/1
Port priority information
Port priority: 0
Port priority trust type: untrust
Table 2-2 display qos trust interface command output description
Interface
Port priority
Port priority trust type
Field
Interface type and interface number
Port priority
Trusted precedence type, which can be dot1p,
dscp, or untrust
2-4
Description