Connecting Rod And Crankshaft End Play Inspection - Honda 2004 Odyssey Service Manual

Engine Block

Connecting Rod and Crankshaft End Play Inspection

1. Remove the oil pump (see page 8-8).
2. Remove the baffle plate (see step 7 on page 7-12).
3. Measure the connecting rod end play with a feeler
gauge (A) between the connecting rod (B) and
crankshaft (C).
Connecting Rod End Play
Standard (New): 0.15 0.35 mm (0.006 0.014 in.)
Service Limit: 0.45 mm (0.018 in.)
C
4. If the connecting rod end play is out-of-tolerance,
install a new connecting rod and recheck. If it is still
out-of-tolerance, replace the crankshaft (see page
7-12).
7-6
B
A
5. Push the crankshaft firmly away from the dial
indicator, and zero the dial against the end of the
crankshaft. Then pull the crankshaft firmly back
toward the indicator; dial reading should not
exceed the service limit.
Crankshaft End Play
Standard (New): 0.10 0.35 mm (0.004 0.014 in.)
Service Limit: 0.45 mm (0.018 in.)
6. If the end play is out-of-tolerance, replace the thrust
washers and recheck. If it is still out-of-tolerance,
replace the crankshaft (see page 7-12).