Flywheel And Drive Plate; Replacement; End Play - Honda Civic 1998 Service Manual

Gonnecting Rod and
Flywheel and Drive Plate Crankshaft
Replacement
Manual Transmission:
Remove the six flywheel bolts, then separate the fly-
w h e e l f r o m t h e c r a n k s h a f t f l a n g e . A f t e r i n s t a l l a t i o n ,
tighten the bolts in a crisscross pattern.
RING GEAR HOLDER
07LAB - PV00100
--4T-1
Htr
ENGINE BLOCK
RING GEAR
Inspect ring gear
teeth for wear or
damage.
12 x 1.0 mm
118 N,m 112.0 kgtm,87 lbl.ftl
RING GEAR HOLDER
07LAB - PV(x'l00
Automatic Transmission:
Remove the six drive plate bolts, then separate the drive
plate from the crankshaft flange. After installation, tight-
en the bolts in a crisscross oattern.
1 2 x 1 . 0 m m
7 - 6
74 N.m {7.5 kgf m,54lblftl
End Play
Conn€Gting Rod End Play:
Standard (New): 0.15 - 0.30 mm {0.006 - 0.012 inl
Service Limit: 0.,[|) mm {0.016 inl
. ll out-of-tolerance, install a new connecting rod.
. lf still out-of-tolerance. replace the crankshaft (see
pages 7-9 and 7-20).
Push the crankshaft firmly away from the disl indicator,
and zero the dial against the end of the crankshaft. Then
pull the crankshaft firmly back toward the indicator; dial
reading should not exceed service limit.
Crankshaft End Play:
Stsndard {N€w): 0.10 - 0.35 mm {0.004 - 0.0lit in}
ServicE Limit:
0.45 mm (0.018 inl
. lf end play is excessive, inspect the thrust wsshers
and thrust surface on the crankshaft.
Replace pans as necessary.
NOTE: Thrust washer thickness is fixed and must not be
changed either by grinding or shimming.
Thrust washers are installed with grooved sides facing
outward.
I
I