Section 3 Dsp Operation; Data Operations Of Dsp Unit; Alu Fixed-Point Operations; Figure 3.1 Alu Fixed-Point Arithmetic Operation Flow - Renesas HD6417641 Hardware Manual

3.1

Data Operations of DSP Unit

3.1.1

ALU Fixed-Point Operations

Figure 3.1 shows the ALU arithmetic operation flow. Table 3.1 shows the variation of this type of
operation and table 3.2 shows the correspondence between each operand and registers.
39
Guard

Figure 3.1 ALU Fixed-Point Arithmetic Operation Flow

Note: The ALU fixed-point arithmetic operations are basically 40-bit operation; 32 bits of the
base precision and 8 bits of the guard-bit parts. So the signed bit is copied to the guard-bit
parts when a register not providing the guard-bit parts is specified as the source operand.
When a register not providing the guard-bit parts is specified as a destination operand, the
lower 32 bits of the operation result are input into the destination register.
ALU fixed-point operations are executed between registers. Each source and destination
operand are selected independently from one of the DSP registers. When a register
providing guard bits is specified as an operand, the guard bits are activated for this type of
operation. These operations are executed in the DSP stage, as shown in figure 3.2. The
DSP stage is the same stage as the MA stage in which memory access is performed.

Section 3 DSP Operation

31
Source 1
Guard
Destination
39 31
0 39 31
Guard Source 2
ALU
GT
0
Rev. 4.00 Sep. 14, 2005 Page 99 of 982
Section 3 DSP Operation
0
Z N V DC
DSR
REJ09B0023-0400