Figure 18.6 Example Of Setting Procedure For Waveform Output By Compare Match; Figure 18.7 Example Of 0 Output/1 Output Operation - Renesas HD6417641 Hardware Manual

Example of Setting Procedure for Waveform Output by Compare Match: Figure 18.6 shows
an example of the setting procedure for waveform output by compare match
Output selection
Select waveform output
Set output timing
Start count operation
<Waveform output>

Figure 18.6 Example of Setting Procedure for Waveform Output by Compare Match

Examples of Waveform Output Operation: Figure 18.7 shows an example of 0 output/1 output.
In this example TCNT has been designated as a free-running counter, and settings have been made
such that 1 is output by compare match A, and 0 is output by compare match B. When the set level
and the pin level coincide, the pin level does not change.
TCNT value
H'FFFF
TGRA
TGRB
H'0000
TIOCA
TIOCB

Figure 18.7 Example of 0 Output/1 Output Operation

[1]
mode
[2]
[3]
No change
Section 18 Multi-Function Timer Pulse Unit (MTU)
[1] Select initial value 0 output or 1 output, and
compare match output value 0 output, 1
output, or toggle output, by means of TIOR.
The set initial value is output at the TIOC pin
until the first compare match occurs.
[2] Set the timing for compare match generation
in TGR.
[3] Set the CST bit in TSTR to 1 to start the
count operation.
No change
No change
Rev. 4.00 Sep. 14, 2005 Page 565 of 982
Time
No change
1 output
0 output
REJ09B0023-0400