Figure 19.7 Sample Flowchart For Receiving Serial Data - Renesas HD6417641 Hardware Manual

Section 19 Serial Communication Interface with FIFO (SCIF)
• Receiving Serial Data (Asynchronous Mode)
Figures 19.7 and 19.8 show a sample flowchart for serial reception.
Use the following procedure for serial data reception after enabling the SCIF for reception.
No
No

Figure 19.7 Sample Flowchart for Receiving Serial Data

Rev. 4.00 Sep. 14, 2005 Page 730 of 982
REJ09B0023-0400
Start of reception
Read ER, DR, BRK flags in
SCFSR and ORER
flag in SCLSR
ER, DR, BRK or ORER = 1?
No
Read RDF flag in SCFSR
RDF = 1?
Yes
Read receive data in
SCFRDR, and clear RDF
flag in SCFSR to 0
All data received?
Yes
Clear RE bit in SCSCR to 0
End of reception
[1] Receive error handling and
break detection:
Read the DR, ER, and BRK
flags in SCFSR, and the
ORER flag in SCLSR, to
[1]
identify any error, perform the
appropriate error handling,
then clear the DR, ER, BRK,
and ORER flags to 0. In the
Yes
case of a framing error, a
break can also be detected by
reading the value of the RxD
Error handling
pin.
[2] SCIF status check and receive
data read:
[2]
Read SCFSR and check that
RDF = 1, then read the receive
data in SCFRDR, read 1 from
the RDF flag, and then clear
the RDF flag to 0. The
transition of the RDF flag from
0 to 1 can also be identified by
an RXI interrupt.
[3] Serial reception continuation
procedure:
[3]
To continue serial reception,
read at least the receive
trigger set number of receive
data bytes from SCFRDR,
read 1 from the RDF flag, then
clear the RDF flag to 0. The
number of receive data bytes
in SCFRDR can be
ascertained by reading from
SCRFDR.