Figure 18.100 Error Occurrence In Pwm Mode 2, Recovery In Phase Counting Mode - Renesas HD6417641 Hardware Manual

(16) Operation when Error Occurs during PWM Mode 2 Operation, and Operation is
Restarted in Phase Counting Mode
Figure 18.100 shows an explanatory diagram of the case where an error occurs in PWM mode 2
and operation is restarted in phase counting mode after re-setting.
1
RESET TMDR
(PWM2)
MTU module
output
TIOC*A
TIOC*B
Port output
TIOC*A/PTE[n]
TIOC*B/PTE[n]
n = 0 to 15

Figure 18.100 Error Occurrence in PWM Mode 2, Recovery in Phase Counting Mode

1 to 9 are the same as in figure 18.97.
10. Set phase counting mode.
11. Initialize the pins with TIOR.
12. Set MTU output with the PFC.
13. Operation is restarted by TSTR.
2 3 4 5 6
TIOR PFC TSTR Match
(1 init (MTU) (1)
0 out)
• Not initialized (cycle register)
High-Z
High-Z
Section 18 Multi-Function Timer Pulse Unit (MTU)
7 8 9 10
Error PFC TSTR TMDR TIOR
occurs (PORT) (0) (PCM) (1 init
0 out)
Rev. 4.00 Sep. 14, 2005 Page 659 of 982
11 12 13
PFC TSTR
(MTU) (1)
REJ09B0023-0400