Install The Keypad On The Control Panel Or Other Devices; Operate The Keypad Apart From The Drive; Install Keypad Apart From Drive - YASKAWA GA700 Technical Manual

2.7 Install the Keypad on the Control Panel or Other
Devices
◆

Operate the Keypad Apart from the Drive

The keypad mounted on the drive can be removed and connected to the drive using a remote control extension
cable up to 3 m long to facilitate operation when the drive is installed in a location where it cannot be easily
accessed. Even when the drive has been installed inside the control panel, it can be operated without the need for
opening/closing the door to the control panel. To order optional accessories, contact Yaskawa or your nearest sales
representative.
◆

Install Keypad Apart From Drive

The following method can be used to install the keypad in locations such as the door of the control panel
containing the drive.
Installation Method
Outside of control panel
Inside of control panel
Note:
Installation support sets are sold separately. Use installation support set B if there are weld studs inside the control panel. Contact
Yaskawa or your nearest sales representative for more information of orders.
NOTICE: Prevent foreign matter such as metal shavings or wire clippings from falling into the drive during drive installation and
project construction. Place a temporary cover over the top during installation and remove the temporary cover before start-up to
prevent overheating from reduced ventilation. Failure to comply could damage the drive.
■
External Dimensions of Keypad
W H
65 106
*1 Minimum bending radius
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual

2.7 Install the Keypad on the Control Panel or Other Devices

Table 2.5 Keypad Installation Method
Description
Simplified installation is possible, and
installation support sets sold separately are
not required.
Keypad does not extend beyond the front of
the control panel.
Figure 2.8 Exterior and Mounting Dimensions
Table 2.6 Exterior Dimensions (mm)
D D1 D2
16 8.2 1.6
Required Tools and Installation
Phillips screwdriver #2 (M3)
• Phillips screwdriver #2 (M3, M4)
• Installation support set A (for mounting
with screws, model: xxx)
• Phillips screwdriver #2 (M3)
• Wrench (M4)
• Installation support set B (nut clamp,
model: xxx)
R W1 W2
*1
53.8 44 15
Support Sets
H1 d
78 M3
37
2