Select Language Of Display For Keypad - YASKAWA GA700 Technical Manual

3.6 Keypad Operation
9.
After about 1 to 2 minutes, Auto-Tuning will complete, and the following screen will appear. Press
.
A list of the parameters that were changed as the result of Auto-Tuning will be displayed.
10.
In the parameter change confirmation screen, press
select [End Tuning] at the bottom of the screen and press
To change a parameter again, press
parameter setting screen appears.
Auto-Tuning is now complete.
Note:
During Auto-Tuning, if for example
Tuning will be discontinued. "Endx" is displayed if, after Auto-Tuning is completed, there appears to be a discrepancy in the tuning
results. Check the cause of the error and perform Auto-Tuning again after fixing the cause, or set the motor parameters manually. Even if
"Endx" is displayed, if it is inferred based on the cause of the detection that an error has not occurred, use the measurement results
obtained from Auto-Tuning as is. Er-xx is displayed if Auto-Tuning did not end normally. Check for the cause of the error and perform
Auto-Tuning again after fixing the cause.
◆

Select Language of Display for Keypad

The following explains how to select the language displayed on the keypad.
1.
Press (Home) to display the HOME screen.
Note:
• [Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [Home] is not displayed for
2.
Press (Menu).
140
or to select the parameter to revise, and press
is pressed or an error is detected, an error code will be displayed on the keypad and Auto-
, press (Back), and then press
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
or to check the changed parameters. Then,
.
to display [Home].
or
. The