YASKAWA GA700 Technical Manual page 389

Name
Analog input AI-A3
Analog monitor AO-A3
Digital inputs DI-A3
Digital output DO-A3
PROFIBUS-DP SI-P3
CC-Link SI-C3
DeviceNet SI-N3
CANopen SI-S3
MECHATROLINK-II SI-T3
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
Model
Highly precise analog references can be configured at high
resolution.
• Input signal level: -10 Vdc to +10 Vdc (20 kΩ) at 4 mA to
20 mA (250 Ω)
• Input channel: 3 channels
Voltage input and current input can be selected with a dip
switch.
• Input resolution
– Voltage input: 13 bits (1/8192) + encoding
– Current input: 1/4096
Analog signals are output to monitor the output state of the
drive (output frequency and output current).
• Output resolution: 11 bits (1/2048) + encoding
• Output voltage: -10 Vdc to +10 Vdc (non-insulated)
• Output channels: 2 channels
Digital speed references and multi-function digital input of
up to 16 bits of resolution can be used.
• Input signals: Binary, 16 bits: BCD4 digits + SIGN signal
+ SET signal
Parameters are used to select between 6 bits, 8 bits, and 12
bits.
• Input voltage: 24 V (insulated)
• Input current: 8 mA
Insulated digital signals for monitoring the operation status of
the drive (alarm signals and detecting zero speed) are output.
Type of output:
• Photocoupler relays: 6 channels (48 V, up to 50 mA)
• Relay contact output: 2 channels (250 Vac at 1 A or less,
30 Vdc at 1 A or less)
This option is used to perform the following operations using
the host controller over PROFIBUS-DP communication.
• Operating and stopping the drive
• Setting and viewing parameters
• Monitoring output frequency, output current, and similar
This option is used to perform the following operations using
the host controller over CC-Link communication.
• Operating and stopping the drive
• Setting and viewing parameters
• Monitoring output frequency, output current, and similar
This option is used to perform the following operations using
the host controller over DeviceNet communication.
• Operating and stopping the drive
• Setting and viewing parameters
• Monitoring output frequency, output current, and similar
Note:
Use options with software versions of 1114 or later.
This option is used to perform the following operations using
the host controller over CANopen communication.
• Operating and stopping the drive
• Setting and viewing parameters
• Monitoring output frequency, output current, and similar
This option is used to perform the following operations using
the host controller over MECHATROLINK-II
communication.
• Operating and stopping the drive
• Setting and viewing parameters
• Monitoring output frequency, output current, and similar
Note:
Use options with software versions of 6108 or later.
9.9 Peripheral Devices and Options
Intended Use Document No.
TOBP
C73060078A
TOBP
C73060079A
TOBP
C73060080A
TOBP
C73060081A
TOBP
C73060082A
SIJPC73060082A
TOBP
C73060083A
SIJPC73060083A
TOBP
C73060084A
SIJPC73060084A
TOBP
C73060085A
SIJPC73060085A
TOBP
C73060086A
9
SIJPC73060086A
389