YASKAWA GA700 Technical Manual page 793

■
18: Torque Detection 2 (N.O.)
Setting Function
18 Torque Detection 2
(N.O.)
Configure the torque detection with parameter L6 [Torque Detection].
ON : The output current/torque exceeds the torque value set with L6-05 [Torque Detection Level
2], or the level has dropped and remained in this state longer than the time set with L6-06 [Torque
Detection Time 2].
Note:
• When configured such that L6-04 ≥ 5, the state in which the output current/torque is less that the detection level of L6-05 is detected
when the time set with L6-06 has elapsed.
• Refer to "L6: Torque Detection" for more information.
■
19: Torque Detection 2 (N.C.)
Setting Function
19 Torque Detection 2
(N.C.)
Configure the torque detection with parameter L6 [Torque Detection].
OFF : The output current/torque exceeds the torque value set with L6-05 [Torque Detection Level
2], or the level has dropped and remained in this state longer than the time set with L6-06 [Torque
Detection Time 2].
Note:
• When configured such that L6-04 ≥ 5, the state in which the output current/torque is less that the detection level of L6-05 is detected
when the time set with L6-06 has elapsed.
• Refer to "L6: Torque Detection" for more information.
■
1A: During Reverse
Setting Function
1A During Reverse
ON : The motor is running in reverse.
OFF : The motor is running forward or is stopped.
■
1B: During Baseblock (N.C.)
Setting Function
1B During Baseblock (N.
C.)
ON : The drive is not in the baseblock state.
OFF : During baseblock
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
V/f CL-V/f OLV CLV AOLV
The terminal turns on when an overtorque/undertorque situation is detected.
V/f CL-V/f OLV CLV AOLV
The terminal turns off when an overtorque/undertorque situation is detected.
V/f CL-V/f OLV CLV AOLV
The terminal turns on when the motor runs in reverse.
Figure 11.95 Reverse Operation Output Time Chart
V/f CL-V/f OLV CLV AOLV
The terminal turns off during baseblock. When the drive is in the baseblock state, the drive output
transistor stops switching, and the DC bus voltage is not output.
11.8 H: Terminal Functions
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
11
793