YASKAWA GA700 Technical Manual page 757

.
Note:
• Turn the terminal ON for 1 ms or more to input the Run command.
• The default setting for b1-17 [Run Command at Power Up] is 0 [Disregard existing RUN command]. The protective function activates
and the will flash quickly if the Run command was enabled when the power was energized. Depending on the application, set
b1-17 = 1 [Accept existing RUN command] if run is permitted.
■
1: LOCAL/REMOTE Selection
Setting Function
1 LOCAL/REMOTE
Selection
Note:
• When the LOCAL/REMOTE selection has been set from the multi-function input terminal, the LOCAL/REMOTE Selection key on
the keypad will be disabled.
•
will be lit when Local Mode is selected.
• When the Run command is ON, it is not possible to switch between Local Mode and Remote Mode.
ON : LOCAL
A mode in which the keypad is used as the Frequency reference source and Run command source
OFF : REMOTE
An operation mode in which frequency reference and Run command settings can be set in b1-01, b1-02
[Frequency Reference Selection 1/2] or b1-15, b1-16 [Run Command Selection 1/2]
■
2: External Reference 1/2 Selection
Setting Function
2 External Reference 1/
2 Selection
Note:
When a Run command is being input, switching between reference sources is not permitted.
ON : b1-15 = [Frequency Reference Selection 2], b1-16 [Run Command Selection 2]
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
Figure 11.73 3-Wire Sequence Wiring Example
Figure 11.74 3-Wire Sequence Time Chart
V/f CL-V/f OLV CLV AOLV
Switches drive control between the keypad (LOCAL) and an external source (REMOTE).
V/f CL-V/f OLV CLV AOLV
Switches between the Run command source 1/2 and Reference command source 1/2 when in
REMOTE mode.
11.8 H: Terminal Functions
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
11
757