YASKAWA GA700 Technical Manual page 352

7.5 Replace the Drive
6.
Install the wiring cover at its original position. Pass the cables through the holes that were cut out of the
wiring cover.
7.
Insert the wired control circuit terminal block and then slide it into the connector.
Slide the control terminal block while aligning the bottom with the guide.
A - Guide
8.
Tighten the fastening screw.
9.
Install the front cover and the keypad at their original positions.
10.
Check o2-04 [Drive Model Selection].
Note:
• If parameter information has been stored in the keypad that was installed prior to replacement, use the keypad to restore that
information.
• To reset the performance life monitors for the parts, set o4-01 to o4-13 [Maintenance Period].
352
Figure 7.26 Reattach the Wiring Cover
Figure 7.27 Insert the Terminal Block into the Connector
Figure 7.28 Secure the Terminal Block
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual