YASKAWA GA700 Technical Manual page 769

ON : Reverse
OFF : Forward
Note:
• The motor will not rotate by only turning this signal ON and OFF. Input the Run command.
• FWD/REV Command (2-Wire Seq 2) cannot be used at the same time as Forward/Reverse Run Command (2-Wire Seq) [H1-xx = 40,
41].
■
44: Offset frequency 1
Setting Function
44 Offset frequency 1
Note:
Refer to "d7: Offset Frequency" for details.
■
45: Offset frequency 2
Setting Function
45 Offset frequency 2
Note:
Refer to "d7: Offset Frequency" for details.
■
46: Offset frequency 3
Setting Function
46 Offset frequency 3
Note:
Refer to "d7: Offset Frequency" for details.
■
47: Node Setup
Setting Function
47 Node Setup
■
60: DC Injection Braking command
Setting Function
60 DC Injection Braking
command
DC Injection Braking cancels if the Run command or JOG command are input.
The following time chart shows the DC Injection Braking function.
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
V/f CL-V/f OLV CLV AOLV
Adds the offset frequency set in d7-01 to the frequency reference. when the terminal is turned ON.
V/f CL-V/f OLV CLV AOLV
Adds the offset frequency set in d7-02 to the frequency reference. when the terminal is turned ON.
V/f CL-V/f OLV CLV AOLV
Adds the offset frequency set in d7-03 to the frequency reference. when the terminal is turned ON.
V/f CL-V/f OLV CLV AOLV
When the CANopen communication option is utilized, the Node Setup function (a function for
setting the drive node address from the host controller) is enabled.
V/f CL-V/f OLV CLV AOLV
If the DC Injection Braking command is input when the drive is performing stopping operation, DC
Injection Braking is applied to stop the motor.
Figure 11.81 DC Injection Braking Time Chart
11.8 H: Terminal Functions
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
11
769