Keypad - YASKAWA GA700 Technical Manual

3.2

Keypad

Sym Names of Controls
bol and Indicators
RUN LED
A
ALM LED
B
microSD card
C
insertion slot
Function Key
F1, F2, F3
D
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
Figure 3.1 Keypad
Table 3.1 Keypad: Names and Functions
Lit while the drive is operating the motor.
The light switches off when the drive stops.
Flashes when:
• The drive is decelerating to stop.
• The drive was issued a Run command and the frequency reference is 0 Hz.
The light flashes quickly when:
• Entering a Run command via the MFDI terminals, then switching to REMOTE while the drive is set to
LOCAL.
• Entering a Run command via the MFDI terminals when the drive is not in Drive Mode.
• Entering a Fast Stop command.
• The safety function shuts off the drive output.
• Pushing on the keypad while the drive is running in REMOTE mode.
• Setting b1-17 = 0 [Run Command at Power Up = Disregard Existing RUN Command] and powering
up the drive while the Run command is active.
Lit when the drive detects a fault.
Flashes when the drive detects:
• An alarm
• An oPE (parameter setting error)
• A fault or error during Auto-Tuning.
The light switches off when the drive is operating normally and there are no alarms or faults present.
Insert a microSD card here to use the data log function.
The functions assigned to
The name of each function appears in the lower half of the display window.
Function
, , and vary depending on the currently displayed menu.

3.2 Keypad

3
107