YASKAWA GA700 Technical Manual page 387

Name
Capacitor type noise filter 3XYG 1003
Momentary power loss 200V class: P0010
recovery unit
400 V class: P0020
Low-voltage manual load
"AICUT" LB series
switch
Name
Frequency meter and
DCF-6A
ammeter
Output voltmeter SDF-12NH
Frequency setting
RH000739
potentiometer (2 kΩ)
Frequency meter scale
RH000850
correction resistor (20 kΩ)
Control dial for frequency
CM-3S
setting potentiometer
Potential transformer UPN-B
Scale plate NPJT41561-1
Name
LED keypad JVOP-KPLEA04xxx
WV001
LCD Operator Extension
Cable
WV003
Installation support set A 900-192-933-001
Installation support set B 900-192-933-002
Name
900-193-209-001
Panel through mount kit 900-193-209-002
900-193-209-003
900-192-121-001
900-192-121-002
UL Type 1 Kit
900-192-121-003
900-192-121-004
900-192-121-005
Braking resistor
EZZ020805A
installation attachment
External mounting
attachment for braking EZZ021711A
unit fin
Name
DriveWizardPlus
DriveWorksEZ
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
Model
This option is placed around the drive input power system to reduce noise emitted
from wiring. This option can also be used in combination with the zero-phase
reactor.
Note:
This option is specifically designed for use on the input side of the drive. Do
not connect this option to the output side.
This option ensure the momentary power loss ride-thru time (power supply is
maintained for 2 seconds) of drives.
PM motors act as generators when coasting to provide voltage to terminals. Install
this option to prevent electric shock.
Table 9.19 Frequency Settings and Monitor Options
Model
This option monitors the output frequency and current using analog signals from
the drive.
This option monitors output voltage using analog signals from the drive.
This option sets the frequency via analog input.
This option adjusts the frequency scaling.
This option is used with the frequency setting potentiometer.
This option adjusts the voltage for meters.
This option is used with the frequency setting potentiometer.
Table 9.20 Keypad
Model
The display is composed of LEDs. This keypad is used for remote operation. Use
connection cables that are no longer than 3 m.
This option is used to connect the keypad and drive (1 m or 3 m).
RJ-45, 8-pin straight-through UTP CAT5e cable
This option mounts the keypad to the control panel (secured with screws).
This option mounts the keypad to the control panel (nut clamp).
Use this option when weld studs are located inside the control panel.
Table 9.21 Attachments
Model
Use this option to mount the drive cooling fin outside of the control panel.
Note:
Current may need to be reduced when using panel through mounting for drives.
Install this kit to an open chassis type (IP20) drive to configure the drive as an
enclosed wall-mounted type (UL Type 1) drive.
Use this option to install a braking resistor to a drive.
Use this option to mount the heatsink for the braking unit outside of the control
panel.
Table 9.22 Engineering Tools
Model
- Engineering tools are used with a PC to configure drives and manage parameters.
- Advanced drive programming can be accomplished by using a PC.
9.9 Peripheral Devices and Options
Intended Use
Intended Use
Intended Use
Intended Use
Intended Use
9
387