YASKAWA GA700 Technical Manual page 112

3.2 Keypad
Note:
• Energizing the drive with factory defaults will display the initial start-up screen. Press
–To prevent the drive from displaying the initial start-up screen, Select [No] from the [Show Initial Setup Screen] setting.
• Press from the Home screen to display the monitors.
• When U1-01 [Frequency Reference] is displayed on the Home screen in LOCAL mode, press
[Reference 1].
• The keypad will display [Rdy] when the drive is in Drive Mode and ready to accept a Run command.
• The drive will not accept a Run command while in Programming Mode. Set b1-08 [Run Command Select in PRG Mode] to accept or
reject a Run command from an external source while in Programming Mode.
–Set b1-08 = 0 [Disregard RUN while Programming] (default) to reject the Run command from an external source while in
Programming Mode.
–Set b1-08 = 1 [Accept RUN while Programming] to accept the Run command from an external source while in Programming Mode.
–Set b1-08 = 2 [Allow Programming Only at Stop] to block changes from Drive Mode to Programming Mode while the drive is in
operation.
Mode Keypad Display
Drive Mode Monitor Display Screen
Parameter Setting Screen
Frequently Used Parameters Screen
Parameter Backup Screen
Programming Changed Parameter / Fault History
Mode Screen
Auto-Tuning Screen
Initial Start-Up Screen
Tool Screen
112
Table 3.4 List of Screens and Functions
Sets monitor display.
Changes parameter settings.
Displays parameters which have been changed from the default settings.
Saves parameters to the keypad as backup.
Displays fault history
Executes Auto-Tuning.
Changes selectable initial settings.
Sets data logs and backlight.
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
(Home) to display the HOME screen.
to change parameter d1-01
Function