YASKAWA GA700 Technical Manual page 40

2.7 Install the Keypad on the Control Panel or Other Devices
Figure 2.13 Panel Cut-Out Dimensions for Mounting to Interior of Control Panel
W
64 + 0.5(2.52 + 0.02)
2.
Remove the keypad and place the keypad connector in the holder on the front cover.
Note:
Insert the keypad connector in the direction of the hooks.
A - Keypad
B - Keypad connector
3.
Mount the keypad to the mounting bracket.
Use the screws supplied with the mounting bracket, and tighten them to a tightening torque of 0.49 to 0.73
N∙m (4.34 to 6.46 lb.∙in.).
A - Keypad
B - Mounting bracket A
4.
Position the mounting bracket to which the keypad has been attached in the control panel, and mount it
from the outside using the screws.
Use the screws supplied with the installation support set, and tighten them to a tightening torque of 0.98 to
1.33 N∙m (8.67 to 11.77 lb.∙in.).
40
Table 2.8 Panel Cut-out Dimensions mm (in.)
H
130(5.12) 45(1.77)
C - Holder
Figure 2.14 Remove the Keypad
C - M3 screws
Figure 2.15 Mount Keypad to Mounting Bracket
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
W1 H1
105 + 0.5(4.13 + 0.02)
d
4.8(0.12)