YASKAWA GA700 Technical Manual page 39

A - Keypad
B - M3 screws
4.
Connect the keypad with the drive using the remote control extension cable.
A - Remote control extension
B - Communications connector
C - Drive
Figure 2.12 Connect the Drive and Keypad with the Remote Control Extension Cable
■
Install inside Control Panel
An internal flush-mount requires installation support set that must be purchased separately. Contact Yaskawa or
your nearest sales representative to order mounting brackets and mounting hardware.
Note:
• The installation procedure and panel cut-out dimensions are the same for both mounting brackets A and B.
• Use a gasket between the control panel and the keypad in environments with a significant amount of dust or other airborne debris.
1.
Cut an opening in the control panel for the keypad.
Refer to the following figure for panel cut-out dimensions.
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
2.7 Install the Keypad on the Control Panel or Other Devices
C - Control panel
Figure 2.11 Mount to Exterior of Control Panel
D - Keypad
E - Cable connector
2
39