Section Safety - YASKAWA GA700 Technical Manual

8.1 Section Safety

8.1 Section Safety
After wiring the drive, safely check that all electrical connects are correct and that all covers are
correctly installed before turning on the power. If the drive is already energized, de-energize the
power and wait at least 5 minutes until the Charge LED completely turns off. Remove the front
cover and terminal cover to access wiring, circuit boards, and other parts. Terminals must only
be used for their intended purpose.
Improper wiring, improper ground connections, and improper repair of protective covers could result in electric
shock, which could lead to equipment damage, injury, and even death.
Only authorized persons qualified in electrical work should perform installation, wiring,
maintenance, inspections, parts replacement, and repairs.
Failure to comply may cause electrical shock.
Do not perform work on the drive while wearing loose clothing or jewelry. Before servicing,
secure loose clothing and remove all metal objects such as watches or rings.
Failure to comply could cause death or serious injury.
Handle keypad batteries properly. Do not attempt to charge the battery or disassemble the
keypad.
Improper handling may result in batteries bursting and igniting, which could cause fire and injury.
Do not disassemble batteries. Do not expose batteries to heat or fire.
Improper handling may result in batteries bursting and igniting, which could cause fire and injury.
Do not perform work on the drive without eye protection. Wear eye protection before beginning
work on the drive.
Failure to comply could result in serious injury.
Only allow qualified personnel to operate a crane or hoist to transport the drive.
Failure to comply could cause death or serious injury from falling equipment.
Use a dedicated lifter when transporting the drive by a lifter.
Failure to comply could cause death or serious injury from falling equipment.
Do not carry the drive by the front cover or terminal cover. Make sure that screws are tightened
properly during transport.
The cover of the drive may come off and the drive may fall if it is carried by the front cover or terminal cover or
if screws are loose, which can result in injury.
The battery remains in use even when power to the drive has been shut off. Be sure to also
remove the battery in the keypad when the drive will be shut off for long periods of time.
Replace the battery with a new one immediately after the expected lifespan has passed.
A dead battery left inside the keypad may leak and damage the keypad and drive.
358
DANGER
Electrical Shock Hazard
WARNING
Electrical Shock Hazard
Preventing Fire
Crush Hazard
CAUTION
Crush Hazard
NOTICE
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual