YASKAWA GA700 Technical Manual page 27

Do not place flammable or combustible materials on top of the drive and do not mount the drive
to flammable or combustible materials. Attach the drive to metal or other noncombustible
material.
Failure to comply could cause death or serious injury.
Do not use the main circuit power supply (Overcurrent Category III) at improper voltages. Before
applying power, make sure the drive rated voltage and the power supply voltage match.
Using the main circuit power supply at improper voltages may result in batteries bursting and igniting, which
could cause fire and injury.
When installing dynamic braking options, perform all wiring exactly as specified in the wiring
diagrams provided.
Failure to do so can result in fire. Improper wiring may damage braking components.
When installing the drive into a closed cabin or cabinet, cool the drive using a cooling fan or
cooler so that the intake air temperature to the drive is 50 °C or less for open chassis type
drives, (IP20) and 40 °C or less for enclosed wall-mounted type (UL Type1) drives.
Failure to follow the instructions may result in the drive overheating and catching fire.
Only allow qualified personnel to operate a crane or hoist to transport the drive.
Failure to comply could cause death or serious injury from falling equipment.
Use screws to securely affix the drive front cover, terminal blocks, and other drive components
prior to vertical suspension.
Failure to comply may result in serious injury or death from falling equipment.
Do not subject the drive to vibration or impact greater than 1.96 m/s
suspended by the cables.
Failure to comply may result in serious injury or death from falling equipment.
Do not attempt to flip the drive over or leave the drive unattended while it is suspended by the
wires.
Failure to comply may result in serious injury or death from falling equipment.
Use a dedicated lifter when transporting the drive by a lifter.
Failure to comply could cause death or serious injury from falling equipment.
Do not carry the drive by the front cover or terminal cover. Make sure that screws are tightened
properly during transport.
The cover of the drive may come off and the drive may fall if it is carried by the front cover or terminal cover or
if screws are loose, which can result in injury.
Prevent foreign matter such as metal shavings or wire clippings from falling into the drive
during drive installation and project construction. Place a temporary cover over the top during
installation and remove the temporary cover before start-up to prevent overheating from
reduced ventilation.
Failure to comply could damage the drive.
Observe proper electrostatic discharge (ESD) procedures when handling the drive.
Failure to comply could result in ESD damage to the drive circuitry.
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
WARNING
Crush Hazard
CAUTION
Crush Hazard
NOTICE
2.1 Safety Precautions
2 (0.2 G) while it is
2
27