YASKAWA GA700 Technical Manual page 351

3.
Insert a wire with prepared ends into the main circuit terminal block.
Note:
• When wiring to terminals +1 and +2, if a jumper connects terminals +1 and +2, first loosen the terminal block screws and
remove the jumper.
•
4.
Tighten the screws to the specified torque.
5.
Check the signal from the wired terminal and use a nipper to clip the cutaway section of the corresponding
wiring cover.
Use nippers as shown in the following diagram when clipping the wiring cover.
A - Cutaway section
Note:
• The shape of the wiring cover differs depending on the drive model.
• Detach the cutaway section of the wiring cover by clipping only the areas that apply to the wired terminal. If areas that do
not apply to the wired terminal are clipped, the protective enclosure will not maintain the IP20 protective level.
• Be careful when clipping the cutaway section of the wiring cover, as the section may fly out in unpredictable directions.
• Process the cross section to prevent the cutaway section of the wiring cover from damaging the electric wires.
• If electrical wires other than those specified by Yaskawa are used, the protective enclosure may not maintain the IP20
protective level, even if the wiring cover is used correctly. Contact Yaskawa or your nearest sales representative for details.
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
Figure 7.22 Loosen Terminal Block Screws
Figure 7.23 Install the Electrical Wire
Figure 7.24 Tighten Terminal Block Screws
Figure 7.25 Clip the Cutaway Section of the Wiring Cover
B - Clip here with nippers
7.5 Replace the Drive
351
7