Led Status Ring - YASKAWA GA700 Technical Manual

3.3

LED Status Ring

The LED Status Ring on the product cover shows the drive operating status.
A - ALM/ERR
B - Ready
LED State
A ALM/ERR Flashing
Flashing
B Ready
Flashing
C RUN
Flashing Quickly
*1 For the details on the difference between the RUN LED's flashing vs flashing rapidly statuses, refer to
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
Lit The drive detected a fault.
The drive has detected:
• An alarm
• An oPExx (parameter setting error)
• A fault or error during Auto-Tuning.
Note:
If the drive detects a fault and an alarm at the same time, this LED will be lit to indicate the
fault.
Off
The drive is in normal operation without alarms or faults present.
Lit The drive is operating or is ready for operation.
The drive is in STo [Safe Torque Off] mode.
• The drive detected a fault.
Off
• The drive received an operation command and no fault is present, but the drive is
inoperable.
Lit The drive is operating the motor.
• The drive is decelerating to stop.
*1 • The drive was issued a Run command and the frequency reference is 0 Hz.
• Entering a Run command via the MFDI terminals, then switching to REMOTE while the
drive is set to LOCAL.
• Entering a Run command via the MFDI terminals when the drive is not in Drive Mode.
• Entering a Fast Stop command.
• The safety function shuts off the drive output.
*1
• Pushing
on the keypad while the drive is running in REMOTE Mode.
• Setting b1-17 = 0 [Run Command at Power Up = Disregard Existing RUN Command] and
powering up the drive while the Run command is active.
Off The motor is stopped.
Figure 3.6 About the RUN LED's Flashing Statuses
C - RUN
Description

3.3 LED Status Ring

Figure 3.6.
113
3