How To Read The Parameter List; Icons And Terms Used To Represent Control Modes - YASKAWA GA700 Technical Manual

10.2

How to Read the Parameter List

◆

Icons and Terms Used to Represent Control Modes

The following table lists terms and symbols used in this section.
Icon
V/f
Parameter is available when operating the drive with V/f Control.
CL-V/f
Parameter is available when operating the drive with Closed Loop V/f Control.
OLV
Parameter is available when operating the drive with Open Loop Vector Control.
CLV
Parameter is available when operating the drive with Closed Loop Vector Control.
AOLV
Parameter is available when operating the drive with Advanced Open Loop Vector Control.
OLV/PM OLV/PM
Parameter is available when operating the drive with Open Loop Vector Control for PM motors.
AOLV/PM
Parameter is available when operating the drive with Advanced Open Loop Vector Control for PM motors.
CLV/PM
Parameter is available when operating the drive with Closed Loop Vector Control for PM motors.
EZOLV
Parameter is available when operating the drive with EZ Open Loop Vector Control.
Hex. MEMOBUS addresses used to change parameters over network communication are represented in hexadecimal
numbers.
RUN Parameter can be changed during run.
EXP Parameters that are enabled in Expert Mode only.
*1 When A1-01 = 3 [Access Level Selection = Expert Level], Expert Mode parameters can be displayed on and set with the keypad.
Refer to for more information on parameters available in Expert Mode.
Note:
Icons in gray indicate that the parameter is not available in control mode.
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual

10.2 How to Read the Parameter List

Description
*1
10
393