YASKAWA GA700 Technical Manual page 45

■
Attach the Conduit Bracket
Remove the front cover.
1.
Remove the screws that fasten the protective covers onto the drive.
A - Screws for fastening protective cover
2.
Press conduit bracket 1 into place while aligning it with the screw holes on the drive. Use the screws to
mount it.
A - Conduit bracket 1
B - Wiring holes
3.
Attach bottom protective cover 2.
Tighten the screws to a tightening torque of 0.98 to 1.33 N∙m (8.67 to 11.77 lb.∙in.).
A - Conduit bracket 2
4.
Attach the front cover.
Reverse the procedure described above to reinstall the conduit bracket.
YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual
Figure 2.24 Remove Screws Fastening Protective Cover
Figure 2.25 Attach Conduit Bracket 1
Figure 2.26 Attach Conduit Bracket 2
2.9 Change the Drive's Enclosure Type
C - Insert in the screw holes of the
protective cover and fasten.
D - Insert in the screw holes of the
front cover and fasten.
2
45