Change The Drive's Enclosure Type; Attach The Protective Cover (Procedure A) - YASKAWA GA700 Technical Manual

High performance type; 200 v class: 0.4 to 110 kw; 400 v class: 0.4 to 355 kw

Hide thumbs Also See for GA700:

Table of Contents

2.9 Change the Drive's Enclosure Type

The enclosure type of the drive is the open chassis type (IP20). The following explains how to change the

enclosure type to the enclosed wall-mounted type (UL Type 1). The procedure for installing UL Type 1 protective

covers is explained.

Install the protective covers before wiring the drive.

The procedure for installing the protective covers differs depending on the drive model. Refer to

2004 to 2056

4002 to 4038

2138 to 2211

4089 to 4168

2257 to 2415

4208 to 4414

Attach the Top Protective Cover

Align the hook on the rear of top protective cover with the hole at the top of the drive to attach the top protective

• Attach the top protective cover so the ( ) mark on the upper surface of the top protective cover is positioned at the front side of the

• Insert the two small protruding hooks on the rear side of the top protective cover into the provided mounting holes near the back of the

drive, then press down on the front side of the top protective cover to fasten the cover into place.

B - Rear side of top protective cover

Insert the tip of a straight-edge screwdriver into the small opening located on the front edge of the top protective

cover. Gently apply pressure as shown in the figure below to free the cover from the drive.

Table 2.10 Procedure for Installing UL Type 1 Protective Covers

Figure 2.22 Attach the Top Protective Cover

Figure 2.23 Remove the Top Protective Cover

YASKAWA ELECTRIC SIEP C710617 01B YASKAWA AC Drive GA700 Technical Manual

D - Front of drive