Avaya S8700 Maintenance Manual page 451

For multi-connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

list measurements ip codec
G.711 Usage
(ERL)
G.711 In Reg
Peg
G.711 Out of
Reg peg
G.723/9 Usage
(ERL)
G.723/9 In Reg
peg
G.723/9 Out of
Reg peg
Services personnel who want to estimate the amount of IP traffic used on IP
trunks versus IP stations can compare the above report with the lines of the list
measurements trunk-group, list performance trunk-group, list measurements
outage-trunk, and monitor traffic trunk-groups reports corresponding to IP trunk
groups. Note that it is required that the switch does not have mixed IP and non-IP
ports in a single trunk group.
555-233-143
Usage in Erlangs of G.711 codecs during the measurement interval.
Includes time that the voice channels are on a call. Usage shall be
measured from the time the voice channel is allocated until it is released.
Calculated by:
(Total Call Seconds) / 3600 where Total Call Seconds is a sum of the
following:
total time (in seconds) that a G.711 resource on a Medpro is in use
total time (in seconds) that a G.711 resource on an IP Media Processor is
in use r
Range: 0–9999.
Total number of times an IP media processor port in the region was
allocated to a G.711 call. Range: 0–65535.
The total number of times an IP media processor port was needed in the
region for a G.711 call, but was successfully allocated to a resource in
another region. Out of Region does not include denials. If "Network
regions are interconnected?" is "n(o)", then Out of Region will always be 0.
Range: 0–65535.
Usage in Erlangs of G.723 or G.729 codecs during the measurement
interval. Includes time that the voice channels are on a call. Usage shall
be measured from the time the voice channel is allocated until it is
released. Calculated by:
(Total Call Seconds) / 3600 where Total Call Seconds is a sum of the
following:
total time (in seconds) that a G.723 or G.729 resource on a Medpro is in
use
twice the total time (in seconds) that a G.723 or G.729 resource on an IP
Media Processor is in use
Range: 0–9999.
Total number of times an IP media processor port in the region was
allocated to a G.723 or G.729 call. Range: 0–65535.
The total number of times an IP media processor port was needed in the
region for a G.723 or G.729 call, but was successfully allocated to a
resource in another region. Out of Region does not include denials. If
"Network regions are interconnected?" is "n(o)", then Out of Region will
always be 0. Range: 0–65535.
Issue 1 May 2002
7-195

Advertisement

Table of Contents
loading

Table of Contents