Ipv6 Ospf Bfd - Dell N1100-ON Reference Manual

ipv6 ospf bfd

Use the ipv6 ospf bfd command to enable sending of BFD events to OSPF on
a VLAN routing interface. Use the no form of the command to disable
sending of BFD events.
Syntax
ipv6 ospf bfd
no ipv6 ospf bfd
Default Configuration
BFD is not enabled by default.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
BFD processing notifies OSPFv3 of level 3 connectivity issues with the peer.
The interface must be a VLAN interfaced enabled for routing.
BFD must also be enabled in OSPFv3 router configuration mode for BFD
processing to occur.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#configure
console(config)#ipv6 unicast-routing
console(config)#interface vlan 3
console(config-if-vlan3)#ipv6 address fe80::1214
console(config-if-vlan3)#ipv6 ospf area 0
console(config-if-vlan3)#ipv6 ospf bfd
onsole(config-if-vlan3)#exit
console(config)#ipv6 router ospf
console(config-router6)#bfd
1207
Layer 3 Routing Commands