System Config > Hosts; System Config > Arp (Address Resolution); Set Static Host Entries; Add New Host - Juniper MEDIA FLOW MANAGER 2.0.2 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

CHAPTER 3 Media Flow Manager Web-Based Interface
Figure 16 System Config > Hostname Page Detail
System Config > Hosts
Set static host entries; a static host is not subject to IP address changes via DNS (dynamic
name sever.
Static Host Entries
View, configured Static Hosts (hostname/IP mappings for /etc/hosts). The default loopback
host entry cannot be removed. Select an entry and click Remove Selected to delete it. See
Figure 17
Click Save at the top of the page to make changes persistent.
Figure 17 System Config > Hosts Page Detail

Add New Host

Add a new host on the System Config > Hosts page; you must know the IP address and
Hostname to enter a static host mapping. See
Click Add Entry to immediately apply changes. Click Save at the top of the page to make
changes persistent.
Figure 18 System Config > Hosts Page Detail
System Config > ARP (Address Resolution)
Manage Address Resolution Protocol (ARP) entries.
44 System Config
for graphic, next.
Media Flow Manager Administrator's Guide
Figure 18 for graphic, next.
Copyright © 2010, Juniper Networks, Inc.