Reset Radius Statistics - 3Com S7906E Command Reference Manual

Use the undo radius trap command to disable the function.
By default, the RADIUS trap function is disabled.
Note that:
If a NAS sends an accounting or authentication request to the RADIUS server but gets no response,
the NAS retransmits the request. With the RADIUS trap function enabled, when the NAS transmits
the request for half of the specified maximum number of transmission attempts, it sends a trap
message; when the NAS transmits the request for the specified maximum number, it sends
another trap message.
If the specified maximum number of transmission attempts is odd, the half of the number refers to
the smallest integer greater than the half of the number.
Examples
# Enable the RADIUS trap function for accounting servers.
<Sysname> system-view
[Sysname] radius trap accounting-server-down

reset radius statistics

Syntax
reset radius statistics [ slot slot-number ]
View
User view
Default Level
2: System level
Parameters
slot slot-number: Specifies the slot where the interface card is inserted.
Description
Use the reset radius statistics command to clear RADIUS statistics.
Related commands: display radius scheme.
Examples
# Clear RADIUS statistics.
<Sysname> reset radius statistics
reset stop-accounting-buffer
Syntax
reset stop-accounting-buffer { radius-scheme radius-scheme-name | session-id session-id |
time-range start-time stop-time | user-name user-name } [ slot slot-number ]
View
User view
2-14