Display Radius Scheme - 3Com S7906E Command Reference Manual

display radius scheme

Syntax
display radius scheme [ radius-scheme-name ] [ slot slot-number ]
View
Any view
Default Level
2: System level
Parameters
radius-scheme-name: RADIUS scheme name.
slot slot-number: Specifies the slot where the interface card is inserted.
Description
Use the display radius scheme command to display the configuration information of a specified
RADIUS scheme or all RADIUS schemes.
Note that:
If no RADIUS scheme is specified, the command will display the configurations of all RADIUS
schemes.
If no slot number is specified, the command will display the configurations of the RADIUS schemes
on only the main processing unit.
Related commands: radius scheme.
Examples
# Display the configurations of all RADIUS schemes.
<Sysname> display radius scheme
------------------------------------------------------------------
SchemeName
Index=0
Primary Auth IP
Primary Acct IP
Second Auth IP
Second Acct IP
Auth Server Encryption Key= Not configured
Acct Server Encryption Key= Not configured
Interval for timeout(second)
Retransmission times for timeout
Interval for realtime accounting(minute)
Retransmission times of realtime-accounting packet
Retransmission times of stop-accounting packet
Quiet-interval(min)
Username format
Data flow unit
Packet unit
= radius1
= 1.1.1.1
= 1.1.1.1
= 0.0.0.0
= 0.0.0.0
Type=extended
Port = 1812 State = active
Port = 1813 State = active
Port = 1812 State = block
Port = 1813 State = block
2-2
=3
=3
=12
=5
=500
=5
=without-domain
=Byte
=one