Secondary Accounting (Radius Scheme View) - 3Com S7906E Command Reference Manual

with the retry stop-accounting command). This means that for each stop-accounting request, if
the device receives no response within 3 seconds, it will initiate a new request. If still no responses
are received within 5 renewed requests, the stop-accounting request is deemed unsuccessful.
Then the device will temporarily store the request in the device and resend a request and repeat
the whole process described above. Only when 20 consecutive attempts fail will the device discard
the request.
Related commands:
stop-accounting-buffer.
Examples
# Set the maximum number of stop-accounting request transmission attempts to 1,000 for RADIUS
scheme radius1.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] retry stop-accounting 1000

secondary accounting (RADIUS scheme view)

Syntax
secondary accounting ip-address [ port-number ]
undo secondary accounting
View
RADIUS scheme view
Default Level
2: System level
Parameters
ip-address: IP address of the secondary accounting server, in dotted decimal notation. The default is
0.0.0.0.
port-number: UDP port number of the secondary accounting server, which ranges from 1 to 65535 and
defaults to 1813.
Description
Use the secondary accounting command to specify the secondary RADIUS accounting server.
Use the undo secondary accounting command to remove the configuration.
By default, no secondary RADIUS accounting server is specified.
Note that:
The IP addresses of the primary and secondary accounting servers cannot be the same. Otherwise,
the configuration fails.
The RADIUS service port configured on the device and that of the RADIUS server must be
consistent.
Related commands: key, radius scheme, state.
reset stop-accounting-buffer,
2-18
radius scheme, display