Retry Realtime-Accounting - 3Com S7906E Command Reference Manual

Use the undo retry command to restore the default.
The default value for the retry-times argument is 3.
Note that:
Because RADIUS uses UDP packets to transmit data, the communication is not reliable. If the
device does not receive a response to its request from the RADIUS server within the response
time-out time, it will retransmit the RADIUS request. If the number of retransmission attempts
exceeds the limit but the device still receives no response from the RADIUS server, the device
regards that the authentication fails.
The maximum number of retransmission attempts defined by this command refers to the sum of all
retransmission attempts sent by the device to the primary server and the secondary server. For
example, assume that the maximum number of retransmission attempts is N and both the primary
server and secondary RADIUS server are specified and exist, the device will send a request to the
other server if the current server does not respond after the sum of retransmission attempts
reaches N/2 (if N is an even number) or (N+1)/2 (if N is an odd number).
The maximum number of retransmission attempts multiplied by the RADIUS server response
timeout period cannot be greater than 75.
Related commands: radius scheme, timer response-timeout.
Examples
# Set the maximum number of RADIUS request transmission attempts to 5 for RADIUS scheme
radius1.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] retry 5

retry realtime-accounting

Syntax
retry realtime-accounting retry-times
undo retry realtime-accounting
View
RADIUS scheme view
Default Level
2: System level
Parameters
retry-times: Maximum number of accounting request transmission attempts. It ranges from 1 to 255 and
defaults to 5.
Description
Use the retry realtime-accounting command to set the maximum number of accounting request
transmission attempts.
Use the undo retry realtime-accounting command to restore the default.
Note that:
2-16