3Com S7906E Command Reference Manual page 1792

Parameters
extended: Specifies the extended RADIUS server (generally iMC ), which requires the RADIUS client
and RADIUS server to interact according to the procedures and packet formats provisioned by the
private RADIUS protocol.
standard: Specifies the standard RADIUS server, which requires the RADIUS client end and RADIUS
server to interact according to the regulation and packet format of the standard RADIUS protocol (RFC
2865/2866 or newer).
Description
Use the server-type command to specify the RADIUS server type supported by the device.
Use the undo server-type command to restore the default.
By default, the supported RADIUS server type is standard.
Related commands: radius scheme.
Examples
# Set the RADIUS server type of RADIUS scheme radius1 to standard.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] server-type standard
state
Syntax
state { primary | secondary } { accounting | authentication } { active | block }
View
RADIUS scheme view
Default Level
2: System level
Parameters
primary: Sets the status of the primary RADIUS server.
secondary: Sets the status of the secondary RADIUS server.
accounting: Sets the status of the RADIUS accounting server.
authentication: Sets the status of the RADIUS authentication/authorization server.
active: Sets the status of the RADIUS server to active, namely the normal operation state.
block: Sets the status of the RADIUS server to block.
Description
Use the state command to set the status of a RADIUS server.
By default, every RADIUS server configured with an IP address in the RADIUS scheme is in the state of
active.
Note that:
2-21