Uni Port-Policy - 3Com S7906E Command Reference Manual

Use the undo uni classification-marking command to remove the configuration.
Examples
# Set the priority of packets whose destination MAC address is 000F-E2D7-925A to 3.
<Sysname> system-view
[Sysname] interface onu 2/0/1:1
[Sysname-Onu2/0/1:1] uni 1 classification-marking index 1 queue 3 priority 3 dst-mac equal
000F-E2D7-925A

uni port-policy

Syntax
uni uni-number port-policy { { inbound { cir cir-value | bucket-depth bucket-depth-value |
extra-burst-size ebs-value }* } | outbound cir cir-value [ pir pir-value] }
undo uni uni-number port-policy { inbound | outbound }
View
ONU port view
Default Level
2: System level
Parameters
uni-number: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
inbound: Configure the traffic policing parameters for inbound packets on the UNI port.
cir-value: Committed information rate (CIR) value – guaranteed bandwidth, in the range 0 to 1024000
Kbps. It must be a multiple of 64 and defaults to 102400.
bucket-depth-value: Bucket depth – the maximum burst bandwidth, in the range 1522 to 65535 bytes.
The default is 1522.
ebs-value: Available extra bandwidth when the maximum burst bandwidth is exceeded. It is in the range
0 to 1522 bytes, and the default is 0.
pir-value: Peak information rate, in the range of 1 to 1024000 kbps. It must be a multiple of 64.
outbound: Configure the traffic policing parameters for outbound packets on the UNI port.
Description
Use the uni port-policing command to configure the traffic policing parameters for the
inbound/outbound packets on a UNI port.
Use the undo uni port-policy command to restore the traffic policing parameters for the
inbound/outbound packets on a UNI port to defaults.
By default, no traffic policing parameter is configured for a UNI.
Examples
# Configure the traffic policing parameters for UNI 1.
<Sysname> system-view
6-9