Primary Accounting (Hwtacacs Scheme View) - 3Com S7906E Command Reference Manual

0s address, all 1s address, a class D address, a class E address or a loopback address.
Description
Use the nas-ip command to set the IP address for the device to use as the source address of the
HWTACACS packets to be sent to the server.
Use the undo nas-ip command to remove the configuration.
By default, the source IP address of a packet sent to the server is the IP address of the outbound port.
Note that:
Specifying a source address for the HWTACACS packets to be sent to the server can avoid the
situation where the packets sent back by the HWTACACS server cannot reach the device as the
result of a physical interface failure.
If you configure the command for more than one time, the last configuration takes effect.
The nas-ip command in HWTACACS scheme view is only for the current HWTACACS scheme,
while the hwtacacs nas-ip command in system view is for all HWTACACS schemes. However, the
nas-ip command in HWTACACS scheme view overwrites the configuration of the hwtacacs
nas-ip command.
Related commands: hwtacacs nas-ip.
Examples
# Set the IP address for the device to use as the source address of the HWTACACS packets to 10.1.1.1.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] nas-ip 10.1.1.1

primary accounting (HWTACACS scheme view)

Syntax
primary accounting ip-address [ port-number ]
undo primary accounting
View
HWTACACS scheme view
Default Level
2: System level
Parameters
ip-address: IP address of the server, a valid unicast address in dotted decimal notation. The default is
0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the primary accounting command to specify the primary HWTACACS accounting server.
Use the undo primary accounting command to remove the configuration.
By default, no primary HWTACACS accounting server is specified.
3-7