ABB IRB 5720 Product Manual page 485

2
Removing and lifting away the lower and upper arms un-separated (Step 2)
Use this procedure for the second step to remove and lift the lower and upper arm
un-separated.
1
2
Product manual - IRB 5720
3HAC079195-001 Revision: A
Action
Remove all but one of the remaining attach-
ment screws that secure the lower arm to
the axis-2 gearbox.
Action
Put two foam boards, pallets or similar
protective material on the floor, somewhere
close to the robot.
Put one higher foam block as protection
for the wrist.
If needed, move axis-1 into a position that
gives the required space.
Note
Keeping the cable harness and DressPack
fitted on the robot during gearbox replace-
ment is only a recommendation. If it is not
possible to put the lower and upper arm
close enough to the robot, the cable har-
ness and DressPack in the base and in the
frame must be removed first.
CAUTION
The weight of the complete upper and
lower arm together is
IRB 5720-180/2.6, IRB 5720-155/2.6 LID:
440 kg
IRB 5720-125/3.0, IRB 5720-90/3.0 LID: 390
kg
All lifting accessories used must be sized
accordingly.
© Copyright 2022 ABB. All rights reserved.
5.9.2 Replacing the axis-2 gearbox
Note
xx2100002411
Note
xx2000000441
Continues on next page
5 Repair
Continued
485